How To Adjust Door Closer Hinge


How To Adjust Door Closer Hinge. This video is filmed on a garage entry door.the process is very simple but not all. Rotate the adjustment lever clockwise and make it face ceiling of the cabinet.

How to Adjust and Troubleshoot Your Commercial Door Closer from www.homebuildershardware.com

Follow these four steps to adjust your composite door hinges and get your door working like new again. Reposition, double and triple check the new position, and drill holes. This will make it easier to access the hinges.

Place The Door In The Closed Position.

Check to see the door stays open and that it. If the cupboard doors are poorly aligned, unscrew the two screws that directly connect to the cupboard vertically. Follow our procedure to get the optimal closing experience.

After Removing The Side Panel, Wipe Off The Latch With Lubricant, Also Apply Grease At The Housing Of The Latch.

If the top of your hinge has a screw to keep the spring protected, you will have to unscrew it. Generally, these screws are in a slotted hole to allow for adjustments. Tighten or loosen in small steps.

Insert The Small Tension Pin Into The Hole.

Insert the hex wrench on top of the hinge. Also, apply lubricant to the handle and latch until it moves freely. Likewise, for a lateral cabinet hinge adjustment to the left, turn the screw counterclockwise.

So, It Will Point Towards The Ceiling.

Let there be 10 millimeters (about an inch) between the tab and hinge when adjusting. So once the screws are loosened, move the hinge up or down slightly, and then simply tighten the screws up. Rotate the adjustment lever clockwise and make it face ceiling of the cabinet.

Unscrew The Screws From The Top Of The Hinge.

This will leave a little gap where the hinge was chopped in. This will make it easier to access the hinges. Once again if it’s a tab instead, you want to pull it forward in a moderate amount.

Tags: ,

Leave a Reply

Your email address will not be published. Required fields are marked *

Related Post