How To Check Gas Hot Water Heater Elements. Locate and remove one or two panels on the side of the water heater. Disconnect the water heater from the electrical circuit breaker panel.
Verify the electricity is off. One of the most typical reasons for your water heater not to be generating hot water is a defective heating element, which is one of several probable causes. Depending on the wattage of the heating element you should get a reading of.
Head Back To The Terminal 1 And Red Wire Of The Bottom Heating Element.
Use a multimeter to inspect the element. Open the water heater’s access panel. 3 on check for flow, clamp the prongs of the multimeter to the element screws.
One Of The Most Typical Reasons For Your Water Heater Not To Be Generating Hot Water Is A Defective Heating Element, Which Is One Of Several Probable Causes.
Once the water comes through the faucet, close the faucet. It has a gas burner at the bottom, with the chimney running up through the middle of the tank. Verify that the power supply has been turned off by testing.
If It Reads 240V, Then There Is Power In The Setup.
Disconnecting leads from terminal strip may be necessary). Otherwise switch off the circuit breaker controlling the unit (note: Assemble the water heater again.
Make Sure The Electricity Is Turned Off.
Here is a more detailed explanation of how to check hot water heater elements. Step #2 open the side panels to reveal the elements. Locate the heating elements by looking at your water heater.
Set The Tip Of One Prong In The Center Of One Of The Screws Holding The Water Heater Element In Place.
Turn off the power supply to the unit at the main electrical panel if possible; How to test if hot water heater element is bad step #1 shut off the power supply. You should get a reading if the element is not faulty.