How To Install A Linear Shower Drain In Concrete Floor

How To Install A Linear Shower Drain In Concrete Floor. Stainless steel square grate linear 2 linear shower drain shower drain walk in shower shower design. To install the shower, drain cover, loosen the bolts on the flange, slide it over the top of the bolts, and turn it until it is locked in place.

Lineup of Linear Shower Drains JLC Online Shower, Tile, Plumbing from

And smooth, so the underside ribs of the base are in full contact with the concrete floor following installation. Now, slide it in between the pipe and the drain body. Install the shower drain into the drilled hole in the concrete.

Also, Build The Flanges Of Both Ends And The Back Flange Just Next To The Shower Wall.

Tightly secure the base drain using the clamp rings to hold the liner in place and create a strong water barrier. If you are using a cast iron or abs pipe, use a jigsaw to cut the hole in the slab. Make a suitable slope on the floor to ensure that the water goes to the shower drain.

Place A Piece Of Plywood Or At A

Last but not least, place the strainer on it. Check the existing drain pipe on the slab floor. First connect the (linear) shower drain to the drainage pipe and make sure that the drain pipe has sufficient slope.

Now, Slide It In Between The Pipe And The Drain Body.

Once you are confident about affixing the drain in the concrete hole fix the hole with dirt or more concrete. Prime the stack and the new drain. When installed properly, their simplistic straight lines and minimalist design makes them popular.

First And Foremost, When Constructing A Shower, Be Sure That Your Subfloor Is Level, Clean, And Structurally Sound.

Trench depth must match the depth of the original drain line’s bottom. 45 linear drain showers bathroom tile installation shower floor tile bathroom lighting. Insert the shower drain into the hole and secure it with a plumber’s putty or silicone caulk.

Remove The Trash And Dispose Of It Properly.

To avoid cavities under the conduit, make sure enough material is used to attach to the top edge of the conduit frame. Slide the drain in the connector, it is. Next, set the shower base and add lubrication to the gasket via the plumber’s soap.

Tags: ,

Leave a Reply

Your email address will not be published. Required fields are marked *

Related Post