How To Measure Belt Size For Pulley References


How To Measure Belt Size For Pulley References. How to measure v belts. Make sure that you don’t rest your ruler along the side of the belt when taking this dimension, as it can slightly skew your results.

V Belt Cross Reference Chart from www.wordacross.net

This measurement technique is standard for newer proper. Sizes can be set for either to be calculated, but usually it is for calculation of the ratio of the two of them. C = center to center distance between shafts.

You Can Find The Belt Length Calculated With This.

Note the construction of the timing belt. The first thing you should do is measure the pulleys outside diameter (o.d). Next, determine the pulley’s wall.

Lay The Belt On A Clean, Flat Surface.

It’s a fact that ignoring outside diameter may lead you towards a wrong size of pulley. Then make a corresponding mark on the floor or a flat surface like a counter or benchtop. Start the tape measure at the hole you use and measure to the end of the belt, where it meets the buckle.

Next, Measure The Pitch Diameter (Pd).

Rubber construction is extremely flexible while a polyurethane construction is plastic like and has little flexibility. Measure the width of the timing belt. This is important to know because it is key in the measurement of your belt.

Well Get Out The Tape Measure And The Calculator.

Lay your leather belt out on a flat surface. Measure pulley between flange width. Yes, you need to measure the od (outside diameter) of v belt pulleys.

These Numbers Come In Handy For The Inventory Crew To Verify Your Measurements By Cross Referencing The Belt Number With The Manufacturer’s Catalog.

Thirdly you put the tape measure in front of your belly where the middle belt hole is usually located and write down the measured length. The idea is that the belt is pulled into the. This is your best reference to find the belt’s original size, type, and length.

Tags: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

Related Post