How To Relight Pilot Light On Rheem Water Heater


How To Relight Pilot Light On Rheem Water Heater. Occasionally, the pilot light on your a.o. However, if done incorrectly, it can be quite dangerous.

How to Reignite Your Water Heater's Pilot Light from www.mrrooter.com

A lot of modern appliances now operate via electronic ignition. Check the lighting instruction label inside the front of your water heater. Keep pressing the ignition button once per second while holding the gas control knob down.

A Faulty Thermocouple Or Malfunction Of The Gas Valve Could Be The Culprit, But The Problem May Be As Simple As A Draft Coming From A Crack In The Wall Or Under The Door.

For instructions specific to your brand of water heater, scroll below. If your label is yellow: Keep an eye on the status light and keep going with the process until it starts to blink.

The Traditional Gas Igniter Is A Standing Pilot, And In The Past, You Had To Light It By Hand Using A Long Match.contemporary Richmond Water Heaters Have Sealed Combustion Chambers, Though, So If They Have Standing Pilots, They Are Equipped With Piezoelectric Spark Igniters.before Trying To Relight The Pilot, Consult Your Owner's Manual To Make Sure That There Is.

Check the lighting instruction label inside the front of your water heater. Depress the control knob fully and keep holding the knob down to allow sufficient gas to flow to the pilot light. Hold the red button down while pressing the piezo ignitor striker, found to the immediate right of the gas knob, repeatedly until the pilot is lit.

Replaced The Thermocouple, But Still Not Working.

This video contains “generalized” instructions. However, if done incorrectly, it can be quite dangerous. Locate the gas valve on your hot water heater and turn it to the “off” position.

Then, Attach The Lead Of The Multimeter To The Thermocouple’s Wires.

Turn the control switch to pilot light mode. Comes on steady, hot and strong. When trying to relight the pilot light, we cannot turn the knob to the “pilot” position in order to get started.

If Your Label Is Yellow:

Listen for a click and the water heater status light should start blinking ignites. Keep your face clear of the combustion chamber. Here here’s how to light the pilot light on a rheem gas water heater.

Tags: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

Related Post